SummaSign Pro T-series Cutters
User’ s Manual
General Information
1-11
1.
RS-232-C Port : -
This DB-9P connector provides the communication link
between the cutter and a host computer. It allows bidirectional
communication between the host computer and the cutter.
2.
Parallel Port : -
This 36-pin Centronics connector provides a unidirectional
communication link between the cutter and a host computer. The cutter
can receive but not transmit data via this port.
Note : only one interface can be active at any one time.
The first port that receives data will be the active interface until the cutter
is reset.
3.
Power
ON/OFF switch
: - This rocker switch sets the cutter’s power to ON or
OFF. To switch the power ON, press the “I” side of the rocker switch. To
switch the power OFF, press the “O” side of the rocker switch.
4.
Power Entry Module : -
The fuse box, the voltage select board and the AC
power cord receptacle are located in the power entry module.
The power-up procedure is explained in detail in Section 1.6.
For information about the conversion of the cutter's operating voltage,
see Section 3.2.
5.
Roll
Media Guide Bushes :
- The two guide bushes serve to keep the
media roll in place when media is pulled from the roll.
6.
Media Flanges
:
- The media flanges ensure proper routing of the media
roll.
7.
Media Support Roller :
- Rotating support rollers for the media roll.
Summary of Contents for T1010 Pro
Page 1: ......
