SummaSign Pro T-series Cutters
User’ s Manual
General Information
1-20
CAUTION
For most vinyl cutting operations, the knife blade tip will be barely
visible at the bottom of the knife tool. If you can clearly see the knife
blade tip, you will probably need to readjust the cutting depth.
To prevent damage to the cutter, check the depth of the knife blade
tip and the quality of the cut each time you load a different type of
vinyl into the cutter.
1.7.2 INSTALLING A KNIFE FOR CUTTING MASKING STENCIL OR HEAVY
MATERIALS
1.
As shown in Figure 1-9, insert the knife blade into the knife holder. Make
sure the knife blade is firmly fixed into the holder. The blade is firmly fixed
when you can not remove it manually from the knife holder. To remove
the blade when it is too blunt, push at the back of the blade with a
screwdriver. The blade will jump out of its holder then.
FIGURE 1-9 :
BLADE ASSEMBLY
2.
Insert the
black
nose piece as shown in Figure 1-10 until it snaps into the
nose piece holder.
When cutting masking stencil always replace the standard nose piece
(grey colour) by the masking stencil nose piece (black colour)
Summary of Contents for T1010 Pro
Page 1: ......
