SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-2
2.1.1. THE LIQUID CRYSTAL DISPLAY
The 32-character liquid crystal display (LCD) contains two lines of 16 characters
each. The LCD provides cutter status information during operations and
displays menu options for the configuration of the cutter.
The contrast of the LCD can be adjusted from the control panel in order to
ensure optimum readability under varying lighting conditions.
Instructions for adjusting the LCD contrast are given in Section 2.6.12.
The various menu and submenu items are always presented in a loop, which
means that, when the last menu or submenu item is displayed, pressing the
appropriate key will automatically take you back to the first item of the same
menu or submenu.
Next to the status messages and/or menu options displayed on the LCD, arrow
symbols representing the
,
,
,
jogging keys and
key will
tell you what keys to press to go to the next menu item (top line of the display)
or to the next value for a given submenu item (bottom line of the display).
2.1.2. THE RESET/LOAD KEY
The
key (RESET/LOAD)
is used to move the origin, to initiate a load
sequence, to reset the cutter, to abort the cut in progress or to recut the last
file. When the
key (RESET/LOAD) is pressed, the cutter goes off line,
suspends all operations in progress and displays the RESET/LOAD menu. Press
the
key until SET ORIGIN, LOAD, RESET, ABORT or RECUT is displayed. To
confirm RESET, ABORT or RECUT press the
key
(ENTER). To execute the SET
ORIGIN instruction move the knife origin using the
,
,
,
jogging keys
and press
the
key (ENTER) to confirm the new origin position. To initiate the
LOAD instruction press the
1
or
2
key to initiate a load sequence for a ROLL or
SHEET respectively. Upon termination of any of these instructions, the cutter
goes on line again.
The SET ORIGIN instruction is used to move the knife origin.
The LOAD instruction is used to initiate a load sequence.
The RESET instruction performs a complete reset of the cutter.
The ABORT instruction simply cancels the cut in progress. Aborting a cut will not
reset the cutter parameters: the parameters which had been selected for the
cut remain in effect.
The RECUT instruction recuts the last file sent to the cutter (provided that it fitted
into the buffer).
Summary of Contents for T1010 Pro
Page 1: ......
