SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-11
2.3.1. KNIFE PRESSURE
The KNIFE PRESSURE submenu is used to set or modify the cutting pressure of the
knife.
The default knife pressure value is 120 grams.
The knife pressure can be set between 0 and 600 grams.
The knife pressure value is set in 5 gram increments.
On the LCD, the active knife pressure value is marked with an *.
Knife pressure setup is explained in detail in section 1.7.1.
2.3.2. PEN PRESSURE
The PEN PRESSURE submenu is used to set or modify the pressure of the ball
point pen.
The default ball point pressure value is 80 grams.
The pressure can be set between 0 and 600 grams in 5 gram increments.
On the LCD, the active pen pressure value is marked with an *.
2.3.3. POUNCING PRESSURE
The POUNCING PRESSURE submenu is used to set or modify the pressure of the
pouncing tool.
The default pouncing pressure value is 120 grams.
The pressure can be set between 0 and 600 grams in 5 gram increments.
On the LCD, the active pouncing pressure value is marked with an *.
2.3.4. KNIFE OFFSET
The KNIFE OFFSET submenu is used to set or modify the distance between the
DRAG
knife blade tip and the centre axis. This routine applies to a
drag knife
only.
The default drag knife offset value is .45 mm.
The value can be set between 0 and 1 mm.
Make sure that the selected knife offset value matches that of the knife. Some
fine tuning may be necessary because of the mechanical tolerances on the
knife. To verify the knife offset, a test can be cut by pressing the
1
key.
If the offset value is set too low, the rectangles will not close.
When the offset value is set too high, the rectangles will be distorted.
The offset test is illustrated below.
Summary of Contents for T1010 Pro
Page 1: ......
