SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-13
2.4
SYSTEM SET UP
2.4.1. CONCATENATION
The CONCATENATION feature increases the speed and quality with which cut
data having a very high resolution is cut. However when changing over to
normal characters again, deactivate concatenation by setting this parameter
to 0.
On the LCD, the active concatenation value is marked with an *.
2.4.2. SMOOTHING
The SMOOTHING feature helps to cut smoother curves when curve data with
many short vectors is received from the computer.
The default setting is OFF.
On the LCD, the active setting is marked with an *.
2.4.3. EMULATE
The EMULATE submenu is used to select the active cutting/plotting language
for the cutter.
The SummaSign Pro cutters support DM/PL , HP/GL and HP/GL/2.
On the LCD, the active plotting language setting is marked with an *.
NOTE
The active cutting/plotting language MUST match the cutting
software.
Always select a language which is supported by the host computer’ s
cutting software.
Whenever possible, select the DM/PL menu option to set the active
cutting/plotting language to Houston Instrument Digital Microprocessor/Plotting
Language (DM/PL). This selection will allow the cutter to operate with DM/PL-
based cutting / plotting software. This language, having special command
extensions for cutting, normally gives superior cutting performance.
Summary of Contents for T1010 Pro
Page 1: ......
