SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-15
NOTE
The baud rate setting of your cutter MUST match the host computer’ s
baud rate setting.
2.4.8. PARITY
The PARITY submenu is used to set or modify the byte format and parity type for
RS-232-C serial communications between your cutter and the host computer.
The default parity setting is bit 8 = 0 (8 data bits, no parity, the 8th bit being a
low bit). The parity can be set to any of the following values:
LCD information
Parity setting
Remarks
BIT 8 = 0
8 data bits, no parity
bit 8 = low (0)
BIT 8 = 1
8 data bits, no parity
bit 8 = high (1)
EVEN
7 data bits, 1 parity bit
parity bit = even
ODD
7 data bits, 1 parity bit
parity bit = odd
On the LCD, the active parity setting is marked with an *.
NOTE
The parity setting of your cutter MUST match the host computer’ s
parity setting.
2.4.9. RTS/DTR
The RTS/DTR submenu controls the Request To Send (RTS) and Data Terminal
Ready (DTR) signals of the cutter’ s RS-232-C serial communications interface
for hardware handshaking.
The RTS/DTR default value is TOGGLE.
RTS/DTR can be set to TOGGLE (hardware handshaking) or HIGH (software
handshaking).
On the LCD, the active handshaking setting is marked with an *.
Summary of Contents for T1010 Pro
Page 1: ......
