SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-17
2.4.13. MEDIA SENSOR
The MEDIA SENSOR submenu is used to activate or deactivate the media
sensors. On the LCD, the active setting is marked with an *.
The sensors detect whether media is loaded or detect the end of media. The
sensors prevent damage to the cutting strip and knife tip.
2.4.14. AUTOLOAD
The AUTOLOAD option enables the user to the change the vinyl unroll
proceedings. When AUTOLOAD is ON , the cutter will automatically unroll the
vinyl when needed. When the AUTOLOAD option is OFF, the operator himself
should unroll enough media before starting to cut.
The default setting is ON. The best results and performance are guaranteed
when using this setting. On the LCD display, the active setting is marked with
an *.
2.4.15. TOOL COMMAND
The TOOL COMMAND is used to determine whether the DM/PL and HP/GL
pen/knife-select commands (the P and SP commands respectively) are
ignored or accepted.
When the TOOL COMMAND option is set to “ACCEPT”, the P or SP commands
will change the selected tool in the cutter according to the suffix that follows
the pen/knife command. The cutter’ s LCD will, e.g. prompt the user with the
following message: “INSERT PEN” when a P2 command is sent. When the TOOL
COMMAND option is set to “IGNORE”, the pen/knife commands are ignored.
On the LCD, the active setting is marked with an *. The default setting is
“ACCEPT”.
2.4.16. LOAD ON W COMMAND
The LOAD ON W CMD submenu will only be displayed if the PLOT LANGUAGE is
set to DM/PL (See Paragraph 2.4.4.). The LOAD ON W CMD determines, when
receiving the DM/PL Window-command (W-command), whether aside from
the scaling function, media is loaded or not. Besides scaling, the W-command
is also very useful when cutting long signs. With the W-command, media
loading will go smoother. Sufficient media will be pulled off the roll at once.
Even when AUTOLOAD is off, there is no need anymore to unroll the media
manually.
Summary of Contents for T1010 Pro
Page 1: ......
