SummaSign Pro T-series Cutters
User’ s Manual
Maintenance and Cleaning
3-3
2. To keep the sensors clean, it is sufficient to wipe them out now and then
with a cotton swab.
3.1.3 CLEANING THE NOSE PIECE
The nose piece may become dirty with accumulated residue from the vinyl
and will result in poor cut quality.
è
To clean the nose piece, proceed as follows:
1. Gently take out the knife or ball-point pen by turning the knife holder
anticlockwise.
2. Observe the orientation of the nose piece first and then push it out of its
holder.
3. Remove any remaining vinyl residue using a brush or a pair of tweezers.
4. Place the nose piece back .
5. Install the knife or ball-point pen holder as described in section 1.7.
Summary of Contents for T1010 Pro
Page 1: ......
