SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-19
2.5
INTERNAL TEST MENU
è
To access any internal test, proceed as follows:
1.
Power the cutter on.
2.
Load cutting or plotting media.
3.
Install a knife or a pen.
4.
Press the
key until INTERNAL TEST is displayed and press the
jogging
key.
5.
Press the
or
jogging key until the desired internal test is displayed.
6.
To perform the test, press the
key.
To exit from this menu and go to another menu, press the
key until the
desired menu is displayed.
To exit from the menus and put the cutter on line again, press the
key.
Figure 2-4 shows the different INTERNAL TEST submenus.
Summary of Contents for T1010 Pro
Page 1: ......
