Roof Assembly
1. Staring at the back slide one 1036x1625 mm roof panel into position using the
cut-out of the ridge as a guide. Make sure the panel is flush with the back of the
building and resting on one half of the truss. Repeat for the other side.
2. Screw roof panels together at the ridge from the inside using 3 x 60 mm screws.
3. Secure roof panels into framework of gable ends using 3 x 40 mm nails per side.
4. Place the 990x1625 mm roof panels next to the back ones and resting on both
trusses. Secure panels together at the ridge from the inside using 3 x 60 mm
screws.
5. Place the 1220x1625 mm panels at the front using the cutout of the ridge as a
guide and resting on the truss. Secure at ridge and into gable walls.
6. Secure panels into trusses at the ridge using a total of 8 x 60 mm nails.
7. Secure along the length of the building into framework of walls using 12 x 40 mm
nails per side.
Felt Roof
1. Measure and cut the required four lengths allowing an overhang of approx 50 mm
on all sides. Starting at the lower edge (the eaves) place one piece of felt along the
length of the building. Secure the felt using felt nails spaced at 100 mm intervals, but
do not nail along centre of building until the piece of felt covering the ridge is in
place.
2. Place another strip along the length of building overlapping the first strip and
overlapping the ridge. Nail into position along both edges of this piece and at both
ends using felt nails spaced at approx 100 mm intervals. Repeat for other side of
roof.
Our Help Line provides support and advice to customers of Summer Garden
Buildings after ordering. For advice before you buy you can phone us free 7 days a
week on 0800 9777828 or visit www.summergardenbuildings.co.uk