II. Assembling your awning
In order to ensure that the awning is assembled correctly, it is essential that you follow these steps in
order:
1) Set the 4 corners on the ground, beginning with the rear corners of the awning by planting the pegs
beneath the motorhome in order to bring the fabric against the outside of your vehicle.
We would recommend that you plant the pegs at a slant in order to give the installation enhanced wind
resistance.
The pegs supplied with this awning are suitable for use in a range of conditions. However, there are a
good number of pegs and it is important that you use only those compatible with the surface in
question (sand, rocks, etc.). Please seek advice from your retailer.
2)
Please close all doors and windows and fit the rear support bars (optional) against the side of your
motorhome.
Slide the flat section into the pocket located close to the roof (Figure 1), adjust the height of the legs
and tie the straps located on the rear flanges around the aluminium bar (Figure 2).
(Figure 1) (Figure 2)
25
Tying your awning down
Awning 3 sides
