6
7
OPTIONAL CONTROLS
20 Minute Remote Timer Touch Pad
Model ECPBT
This 20-Minute Touch Pad MUST be connected to the
“CT” terminals on the HRV exterior. This control will not
function if connected to PBT connection points.
Install using 18/2-thermostat wire. Maximum number of
ECPBT controls per HRV is eight.
Maximum cumulative lead length is 2000 lineal feet.
Touch pads are typically installed where 20 minutes of
high speed ventilation may be desired.
Once activated by a momentary push of the SELECT
button on the Touch Pad (approximately 3 seconds),
the HRV is switched to high speed ventilation and the
Touch Pad LED will illuminate. The HRV will reset to
the previously selected mode of operation once the 20
minutes have expired. To cancel the selection, depress
the SELECT button on the 20-minute Touch Pad for
a minimum of 3 seconds. The selection can also be
cancelled at any other optional control by momentarily
depressing the SELECT button.
NOTE: This control will not respond while a crank timer
is operational.
