8
Reversing the Door Swing:
NOTE:
Models with professionally installed door handles are not user-reversible.
If you find the direction of opening the door of the appliance inconvenient, you can change it.
Holes on the opposite side have already been prepared at the factory.
This appliance can be opened from either the right side or the left. By default, the door hinge
is on the right side. If you prefer it on the left, please follow these instructions:
1. Take off upper hinge cover from the door and remove the screws that hold top hinge.
2. Lift the hinge straight up to free the hinge pin from the socket in the top of the door.
3. Lift the door up and away to free its bottom socket from the hinge pin.
4. Remove the screws to the bottom hinge.
5. Remove the decorative caps from the opposite side and plug the holes from the original
side with the decorative caps.
6. Move the bottom hinge to the opposite side and tighten the screws. Use any lock washers
or nuts if they were used in the original installation.
7. Replace door onto the hinge pin on the bottom hinge. Place top hinge pin into door. Insert
screws into the top hinge and tighten.
Door Handle Installation:
The door has two screw holes on each side, allowing you to install a handled (included). To
do so, align the handle with the screw holes on the side you prefer. Fix the handle in place,
with the included screws, then cover the screw heads with the handle seal (included).
1
Upper hinge cover
2
Upper hinge
3
Lower hinge
4
Kick plate
5
Handle
6
Fastener at corner with hole
