Page 4
MPE-200 Guide to Operations
1.
UNPACKING
AND
CONNECTING
1.1
Carefully unpack the unit and report any shipping damage
promptly to your Summit dealer and to the carrier.
1.2
The MPE-200 is normally shipped set up for 115 volt AC
(100-125 volts is OK).
For 200-230 and 230-250 volt AC operation, the rear
panel voltage selector should be set to 240v. The fuses
should be slow-blow type, 0.8 amp for 90-125v or 0.4
amp for 200-250v.
ATTENTION:
UTILISER UN FUSUBLE DE RECHANGE DE MEME TYPE
DE 0.8 A - 90-125v, 0.4 A - 200-250v.
ATTENTION:
DEBRANCHER AVANT DE REMPLACER LE FUSIBLE.
For more information on fuses and voltage selection, see
section 8 at the back of this manual.
1.3
Turn the unit on by using the rocker switch at the rear power
entry. For rack mounting, leave this power switch on, and use
the front panel Sleep control to turn off or on. See section 7
for details.
1.4
Due to its Class A circuit design, the MPE-200 will run warm.
Its quiet, low-speed fan ensures safe operation over a wide
range of ambient temperatures.
Be careful not to block the vent holes on the right side
panel or the fan opening on the rear of the MPE-200.
!
!
!
!
!
!
!
!
!
