7
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Installation Instructions
Before Using Your Appliance:
Remove the exterior and interior packing.
CAUTION:
After unpacking you MUST allow this appliance to stand upright for at least 2
hours to allow the lubricant and refrigerant to drain back into the compressor and
stabilize. Failure to do so may adversely affect performance and the lifetime of this unit.
Remove the shelves and clean them and the interior surfaces of the unit with
lukewarm water using a soft cloth.
Installing the Refrigerator:
Place the unit on a floor that is strong enough to support the appliance when it is fully
loaded. To level the unit, adjust the two leveling legs at the front.
Your appliance can be installed either free-standing, recessed or built into an
enclosure. When installing as a free-standing unit, allow at least
2” (51mm) of space
at the sides, top and rear of the unit to allow for proper air circulation to cool the
compressor and condenser.
Even when built in, the unit requires at least 2” of
clearance at t
he back, 1/8” (3mm) at both sides and 1/16” (1.6mm) at the top. Take
care that the air vents at the front of the appliance are never covered or blocked in
any way.
Locate the unit away from direct sunlight and sources of heat (oven, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extremely cold ambient temperatures may also affect the
unit's performance.
Avoid locating the unit in moist areas. Too much moisture in the air will cause frost to
form quickly on the evaporator, requiring more frequent defrosting of the interior.
Plug the unit into an exclusive, properly installed and grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a
certified electrician or authorized service center.
Electrical Connection:
This unit should be properly grounded for your safety. The power cord of this unit is
equipped with a three-prong plug which mates with a standard three-prong wall outlet to
minimize the possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power
cord supplied. For personal safety, this appliance must be properly grounded.
Summary of Contents for accucold AL75 Series
Page 27: ...27 Notes...
