5
LOCATION OF PARTS
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
CAUTION:
After unpacking you
MUST
allow your appliance to stand upright for at least 2 hours to
allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so may
adversely affect performance and the lifetime of the unit.
Clean the interior surface with lukewarm water using a soft cloth.
Reverse the door, if desired. (See page 7.)
(NOTE: The door of model FFAR25L7BICSS is not reversible.)
INSTALLATION OF YOUR APPLIANCE
The appliance is designed for built-in installation but may also be installed free-standing.
WARNING
: Do not store or install the appliance outdoors.
CAUTION
:
This appliance is designed for storing and cooling foodstuffs. Do not store pharmaceuticals
or other medical products.
Place your refrigerator on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs.
For built-
in installation, it is a must to keep ¼” (6.35mm) of space on each side and at the top and 2”
(51mm) at the rear. Take care that the air vent at the front of the appliance is never covered or blocked
in any way.
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
Avoid locating the unit in moist areas.
Plug the appliance into an exclusive, properly grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center.
Summary of Contents for FFAR25L7BI
Page 11: ...11 NOTES...
