EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly recommended that you do not
use an extension cord with this appliance. However, if you must use an extension cord it is absolutely
necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding
type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes.
REVERSING THE DOOR SWING OF YOUR APPLIANCE
This unit has the capability of the door opening from either the left or right side. The unit is delivered to
you with the door opening from the left side. Should you desire to reverse the opening direction, follow
the following reversal instructions.
1. Lower Door Hinge
2. Lock Screws 3. Door Shaft Assembly
4. Glass Door
5. Door Axle
NOTE:
All parts removed must be saved to allow the door swing to be reversed.
1. Open the glass door (4) and remove the two lock screws (2) holding the door shaft assembly (3) to the
glass door. Be careful to hold the glass door firmly after removing the screws. (
Fig. 1
)
2. Pull down to remove the glass door and place it on a padded surface to prevent scratching.
3. Remove the two screws from the door bottom at left side and install them to the door bottom at right
side. (
Fig. 3
)
4. Remove the lower door hinge (1) and rotate it 90°, then install it at the designated position on the left
side. And install the door shaft assembly (3) accordingly. (
Fig. 2
)
5. Remove the door axle (5) from right upper hinge, then install and tighten it in the left upper hinge. (
Fig. 4
)
6. Set the glass door into the designated position and install the two lock screws (2) to connect the door
shaft assembly (3) with the glass door. Tighten them before the door is leveled. (
Fig. 5
)
7. Remove the handle from the left side of the door and install it on the right side. (
See next section
.)
7
