BLIND SETUP
1.
Remove blind from carrying bag.
2.
Pick the blind up by the top hub and extend the legs as shown in
figure 1
.
3.
Lay the blind flat on the ground. Extend the two accessible legs and “lock” them into position. Do this by pulling out on the
center of the leg as shown in
figure 2
.
4.
Flip the blind over and lock the remaining two legs.
5.
Sit in front of the closed end of the blind and place both feet on the top of the center hub. Make sure your feet are on either
side of the hub grommet with the center hole open. See
figure 3
.
6.
Once your feet are secure, grab the pull rope and pull back. At the same time, extend your legs and rock back to pick the
blind up off the ground. See
figure 4 and 5
.
7.
Pull the rope until the center hub shaft pops through the hole and locks as shown in
figure 6
.
8.
Stand the blind upright. On the inside of the blind fasten the safety strap around the hub as shown in
figure 7 and 8
.
1
INDEX
GENERAL WARNINGS AND PRECAUTIONS
PG 1
SECTION 1 - INDEX
PG 2
SECTION 2 - BLIND SETUP
PG 2-3
SECTION 3 - BLIND TAKE DOWN
PG 3
SECTION 4 - QUICK CARRY
PG 4
SECTION 5 - WARRANTY
PG 4
2
BLIND SETUP
1
2
3
PG 2
PG 3
www.summitstands.com
WARNING
!
NEVER
allow your hands to get near the working
parts around the blind hub when opening or
closing the blind.
See image to the right.
WARNING
!
ALWAYS
inspect the pull rope before use. If
excessive fraying or damage is seen, do not use the
rope. Contact Summit for replacement options.
See image to the left.
