PG 23
PLATEFORME
1.
Placez le support du siège et l’échelle tel qu’illustré à la
figure 7
.
Note: Le support en ‘’U’’ soudé fait face à l’arbre
lorsque assemblé.
Glissez le support du siège dans l’échelle et
alignez les trous des boulons.
2.
Placez la plateforme tel qu’illustré à la
figure 8
.
3.
Glissez la plateforme vers l’avant et alignez les trous des
boulons de
l’étape 1
.
4.
Placez le repose-pied. Alignez-le avec les mêmes trous de
l’étape 1 et 3
. Insérez une
bague ¼ po.
entre le repose-pied et
le tube du support du siège
(voir la figure 9)
.
5.
Sécurisez le repose-pied, la plateforme, le support du siège
et la section de l’échelle en utilisant deux
boulons 2 ¾ po. et
des écrous de blocage
.
(voir figure 10)
. Serrez ces boulons à la
main.
6.
Placez une des barres de la plateforme tel qu’illustré à la
figure 10
. La barre devrait être installée à partir de l’intérieur
du montant jusqu’à l’extérieur de la plateforme tel qu’illustré.
7.
Sécurisez le trou supérieur et inférieur en utilisant un
boulon 1 ¾ po. et un écrou de blocage
. Serrez ces boulons à la
main jusqu’à ce que les deux barres soient attachées.
8.
Répétez la procédure pour l’autre côté.
9.
Serrez au moyen d’une clé les boulons de
l’étape 5 et 7
.
7
SUPPORT
DE SIEGE
ASSEMBLAGE
ÉCHELLE
11
MÉTAL DÉPLOYÉ
ENLEVÉ POUR
PLUS DE CLARTÉ
SUPPORT DE
PLATEFORME
(PN 82068.030)
1 3/4” BOULONS, ÉCROU DE
BLOCAGES - SERRER À CLÉ ÉTAPE 9
8
PLATEFORME
(PN 82068.100)
2 3/4” BOULONS, ÉCROU DE
BLOCAGES - SERRER À CLÉ ÉTAPE 9
10
9
REPOSE-
PIEDS
(PN 82068.400)
BAGUES
SUPPORT EN ‘’U’’
SOUDÉ FAISANT FACE
À L’ARBRE
SECTION
SUPÉRIEURE
DE L’ÉCHELLE