6
I
NSTALLATION
1. This unit is intended for indoor use only.
2. Electrical Connection
a. The unit should be plugged into a 115V±10% 60Hz, grounded wall receptacle.
b. Do not plug other electrical units into the same wall receptacle as this unit.
c. Do not use an extension cord.
d. Compressor warranties are void if the compressor burns out due to low voltage.
3. Check points for selecting location
a. The minimum clearance between the back of the cabinet and wall should be at least
7 inches.
b. Keep the unit away from sunlight and other heat generating equipment.
c. The unit should be properly leveled to provide adequate drainage.
4. Installing casters
a. Install casters in the weld nut in the bottom of the unit.
b. Make sure that casters with brakes are installed in front.
5. Install shelves using shelf clips provided in the accessory pack.
CAUTION: This unit uses a flammable refrigerant. Use care when handling and operating to
avoid damaging the refrigerant tubing or increasing the risk of a leak.
MAINTENANCE & CLEANING
All service should be performed by factory-authorized personnel. All component
parts will be replaced with like components to minimize the risk of possible ignition
due to incorrect parts or improper service.
1. The interior surface of the cabinet should be periodically cleaned with a solution of warm
water and baking soda. This solution will help to remove any odors from spillage that
has occurred. The exterior of the cabinet should also be cleaned frequently with a
stainless steel cleaner, glass cleaner or mild soap solution. Do not use chlorinated
cleaners on the stainless steel surface.
2. The drain pan next to the condensing unit should be checked once every 2 weeks and
emptied when necessary.
3. The door gaskets should be periodically cleaned with a mild soap solution to extend
their life.
4. The shelving can be cleaned in a sink with a mild soap solution and soft bristled brush.
5. Condenser Coil
Before cleaning the condenser coil, unplug the unit. Periodically cleaning the condenser
coil will help the heat exchange of the refrigeration system and increase the efficiency.
