background image

 

Do not attempt to repair or replace any part of your appliance unless it is specifically recommended in 
this manual. All other servicing should be referred to a qualified technician. 

 
 
 
 
 

FOLLOW WARNING CALLOUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL 

 

Use two or more people to move and install appliance. Failure to do so can result in back or other 
injury. 

 

To ensure proper ventilation for your appliance, 5 inches (127mm) of space should be kept around 
the back, top and sides of the unit to allow proper air circulation to cool the compressor and 
condenser. Choose a well-ventilated area with temperatures above 60°F (16°C) and below 90°F 
(32°C). This unit must be installed in an area protected from the elements, such as wind, rain, water 
spray or drips. 

 

The appliance should not be located next to ovens, grills or other sources of high heat. 

 

The appliance must be installed with all electrical, water and drain connections in accordance with 
state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in 
accordance with the National Electrical Code and local codes and ordinances, is required. 

 

Do not kink or pinch the power supply cord of the appliance. 

 

The size of the fuse (or circuit breaker) should be 15 amperes. 

 

It is important that the appliance be leveled in order to work properly. You may need to make several 
adjustments to level it. 

 

All installations must be in accordance with local plumbing code requirements. 

 

Make certain that the pipes are not pinched, kinked or damaged during installation. 

 

Check for leaks after connection. 

 

Never allow children to operate, play with or crawl inside the appliance. 

 

Although the unit has been tested at the factory, due to long-term transit and storage, the first batch 
of cubes must be discarded. 

 

 

Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damage 
or discolor the interior. 

 

Use this appliance only for its intended purpose as described in this 

Instruction Manual

 

Keep fingers out of the “pinch point” areas. Clearances between the doors and between the doors 
and cabinet are necessarily small. Be careful closing doors when children are in the area. 

 
 

                                     Risk of child entrapment! 

 

Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are 
still dangerous, even if they will “just sit in the garage a few days”. 

Before discarding your old refrigerator: 

 

Take off the doors 

 

Leave the shelves in place so that children may not easily climb inside. 

 
 

- SAVE THESE INSTRUCTIONS - 

 

 

4

Summary of Contents for SCR1005













Reviews: