Summit SCR1505, Instruction Manual

INSTALLING SHELVES 

Your refrigerator contains 4 wire shelves and 16 shelf clips. 

To install shelves, first place the shelf clips in the slots in the pilasters in the cabinet interior.  Use the 
numbers on the pilasters as a guide in placing the clips at the same distance from the cabinet floor, with 
the tab pointing up as shown.  Once all clips are in place, install the shelves by placing them on the clips, 
with the outside bar of the shelf on the inside of the clip tabs.  Keep all product inside the limits of the 
shelves.  These allow airflow and should not be blocked when product is stocked in the unit. 

CAUTION:

 DO NOT STOCK PRODUCT UNTIL SHELVES ARE 

CORRECTLY INSTALLED IN THE UNIT WITH SHELF CLIPS. 

IMPORTANT:

 TO AVOID ACCIDENTS WHEN CLEANING INSIDE 

OF UNIT, FIRST REMOVE SHELVES AND SHELF CLIPS. 

ELECTRICAL SYSTEM 

Proper electrical installation is required for your refrigerator to function correctly and to prolong the useful 
life of electrical parts and compressor. 

BEFORE CONNECTING UNIT FOR FIRST TIME: 

Verify that line voltage does not fluctuate more than 
10% above the nominal value of 115 V, 60 Hz. 

DO N

OT 

use extension cords. 

o multiple plugs or 

 socket. 

DO NOT 

connect refrigerator t

plugs with another appliance connected. 
The unit 

MUST

 be plugged into a grounded

IMPORTANT: 



Do not try to repair any portion of the electrical system yourself.  Contact the nearest 
authorized service center. 



The unit must be grounded. 



Ignoring any of the precautions in this manual invalidates the Warranty. 



The unit must be connected to a circuit breaker with a 15-ampere fuse and installed 
with a minimum 14-caliber wire. 

8