O
PERATION
As far as possible, angles (a) and (b) at the universal joints
should be the same at both ends of the telescoping drive line.
In applications where this is not the case (e.g. sharp turns
with PTO engaged), it is recommended to use a continuous-
velocity drive shaft.
NOTE:
The two schematic drawings do not show any guards
on the telescoping drive line. A guard is mandatory when
using telescoping drive lines.
IMPORTANT:
Only operating conditions described in the
operator's manuals of the various implements are permitted.
This applies particularly to maximum permissible angle of
articulation, to the use of freewheel clutches and overload
clutches, and to the prescribed amount of overlap when
IMPORTANT:
Before using a PTO-driven
implement, take action to ensure that the
telescoping drive line is lubricated
regularly. Comply with instructions in the
operator's manual provided by the
manufacturer.
engaging pipes are pushed together.
IMPORTANT:
On multi-component
telescoping drive lines, the yokes at each
end must be aligned as shown. The yokes
at each end must not be at 90° to one
another.
PTO drive shaft
IMPORTANT:
PTO transmission system has no one way
clutch. With implements rotating in high speeds such as
rotary mower & leaf blower, be sure to select and use a
drive shaft with one way clutch.
Before attaching PTO drive shaft to tractor and implement, be
sure to check and adjust the drive shaft length to avoid
transmission damage.
Minimum overlap at fully extended: 3.9 inch(100 mm).
If the length of drive shaft is too short, it causes damage to the
PTO shaft and transmission of tractor and/or implement by
slipping out the drive shaft when lowering the implement.
Minimum clearance to the female shaft end at fully retracted
position should be 1 inch(25 mm) .
If the length of drive shaft is too long, it causes damage to the
PTO shaft and transmission of tractor and/or implement
when lifting the implement.
3.94 inch(100 mm)
0.98 inch(25 mm)
40-9
Summary of Contents for TX25H
