14
NOTE :
The battery has been previously charged by the manufacturer. If the LED brightness is low, the electrical charge
may have dropped during storage. It is advisable to charge the lamp for a whole day for its first use.
•
You can "collect" sunlight and recharge your battery for several days by turning the switch to the "OFF"
position. When it is put into service, in the "ON" position, you will have a more lasting light during your evenings.
•
It is best to have direct sunlight, to increase performance. Make a wise choice for your location, avoid gray areas and
if possible orient it towards the South.
•
The number of operating hours depends on the geographic area, weather conditions and the season.
•
Thanks to its Night-Day design,
the LOOMI NEO
can light up in the dark but also in the middle of the day; very useful
function to illuminate a dark room or garage without even a window of day.
Loading the product with its solar panel :
•
Connect the deported solar panel to its projector with its 5 meter cable.
• The device starts to charge and the charge indicator turns red.
• When charging for the first time, the lamp must remain charged for at least 8 hours, the lamp battery will take
approximately 8 hours to recharge afterwards.
• The more the load increases, the more the red indicator light increases and the bar fills.
USE OF LOOMI NEO
IMPORTANT:
The projector is delivered partially loaded in "OFF" mode. Position the button under the projector in “ON”
mode to be able to turn it on.
• You then have the remote control to use your device.
• 100% autonomy ≤ 4 hours, 50% ≤ 8 hours.
Putting the projector into operation:
The projector is partially delivered, loaded in "OFF" mode.
Once the first full charge of 8H has been made, it is imperative to position the button located on the bottom of the
projector in "ON" mode.
Attention, always make sure that the button is ON when you want to light it.
The remote control will be useless and will not work if the button is OFF.
Once the "ON" button is activated, you can control your projector using its remote control.Once the "ON" button is
activated, you can control your projector using its remote control.
ON/OFF BUTTON
