EV40 User’s Manual
Mounting the
SAE J1772™
Connector Holster
The
SAE J1772™ connector holster is an available option to provide a convenient protective
housing for the SAE J1772™ connector head when it is not in use.
• The
SAE J1772™connector holster should be placed so that users have easy and safe
access to the SAE J1772™ connector.
•
For indoor installation, mount the SAE J1772™ connector holster between 18 and 48
inches above the ground or grade.
•
For outdoor installation, mount the SAE J1772™ connector holster between 24 and 48
inches above the ground or grade.
•
The SAE J1772™connector holster has two vertically aligned mourning holes spaced 5.45”
apart, one each on the enclosure top and bottom. Use a ruler or template to mark the hole
locations on the mounting surface.
•
The vertical alignment of the EV40 and SAE J1772™connector holster mounting holes
allows for the convenient mounting of both components onto the same post or wall
structure. For example, the holster may be mounted directly above the EV40.
•
Place the SAE J1772™ connector holster such that both mounting holes take advantage of
solid structural framing inside the wall or a strong wall surface such as plywood.
•
A set of exterior wood screws and stainless steel washers are included for the purpose of
mounting the SAE J1772™ connector holster to a wooden surface.
•
For mounting to a solid surface such as concrete, brick or stone, alternate hardware may
need to be procured. Examples of solid-wall mounting hardware include multi-sets, wedge
anchors, and sleeve anchors. Use the type of mourning hardware most appropriate for the
supporting structure.
Figure 7. Mounting the holster using the exterior wood screws and washers
Page 13