EV40 User’s Manual
FCC INFORMATION
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
This product has been designed to protect against Radio Frequency Interference (RFI). However
there are some instances where high powered radio signals or nearby RF-producing equipment
(such as digital phones, RF communications equipment, etc.) could affect operation.
If interference to your charge station is suspected, we suggest the following steps be taken before
consulting your Sun Country Highway Sales and Service Representative for assistance:
1. Reorient or relocate nearby electrical appliances or equipment during charging.
2. Turn off nearby electrical appliances or equipment during charging.
Caution
Changes or modifications to this product by other than an authorized service
facility could void FCC compliance.
Attention:
Modifications apportées à ce produit par quiconque autre qu'un centre de
service autorisé peut annuler la conformité FCC.
OPERATION
The EV40 Electric Vehicle Charging station is a compact wall or pedestal-mounted charging
station that provides the Plug-in Hybrid or Battery Electric Vehicle (together Plug-in Electric
Vehicles, or ‘PEV’) user with a safe and manageable link between the power grid and the PEV.
Both hardwired (EV40) and NEMA plugin equipped (EV40P) versions are available.
The EV40 is very easy to use Just unwrap the SAE J1772™ charge cable and plug the charge
coupler firmly into the vehicle’s charge port.
Normally, the vehicle will immediately request a charge using a special communication line in
the cable. Within a few seconds the green ‘Charging’ light on the face of the EV40 will turn on
and the charge cycle will begin. After an average driving day the vehicle battery will require a
few hours to recharge completely. Charging overnight is the most convenient way to maintain
healthy batteries and ensure you vehicle’s full range will be available for the next day.
When the vehicle has stopped charging, the green ‘Charging’ light on the EV40 will turn off. To
remove the charge coupler once the charge cycle has competed (or to interrupt a charge in
progress) press and hold down the latch release lever on the charge coupler handle then un-plug
the charge coupler from the vehicle charge port.
Page 4