1. Carefully follow the installation instructions provided by the motor manufacturer. Be sure to attached the color-coded wires to the
proper terminals. Do not install the motor with the boat in the water.
2. Install the battery (not included). The battery should be either a F24 or F27 RV/Marine Deep cycle 12 VDC battery. Position the
battery so the terminals are closest to the back seat. Be sure to attach the battery leads to the proper poles. Red is positive (+) and
black is negative (-). Secure the battery with the battery strap. DO nOT transport the boat on a trailer or pick up truck with the
battery installed. Bouncing and jarring of the battery during transport could crack the battery compartment.
3. Install the prop on the motor using the shear pin and prop nut. Make sure the prop nut is snug.
4. The control panel has a forward/reverse and speed control switch. It provides five forward speeds and three reverse. Lower the
motor to the operating position by pressing the spring in the middle to break the spring tension. Do not operate the motor in the
“uP” position. Stay clear of the prop. The motor should rotate counter clockwise. Set the direction control switch to REVERSE
and repeat procedure. The motor should turn clock-wise. All five speeds in forward and three in reverse should operate properly. If
they don’t review the wiring diagram carefully and make sure all wires are connected to the proper terminals. If the unit still fails to
operate properly, contact the motor manufacturer for assistance.
5. You should be able to operate your electric pedal boat 2-5 hours on a fully charged deep cycle marine battery. Running the motor
at less than top speed significantly extends the time before the battery needs recharging. If the battery should run down to the
extent that progress is unsatisfactory you have the option of manually pedaling the boat to supplement the thrust of the motor.
Paperwork
warranty registration
To properly register your boat with KL Industries for warranty validation please fill out the warranty registration
form online at www.sundolphin.com. Please review our full warranty statement. If you are unable to register
your boat online please contact our Customer Support Department at 231-733-2725. The serial number can
be found on the outside of the hull in the back right corner just under the rubrail. See Photo #2.
Manufacturers statement of Origin (MsO)
You should receive a MSO with your new boat. Some states may require a MSO for proper registration of your
boat. If you plan on putting an electric motor on then it may be necessary to register it. Please check with your
local dealer or state licensing bureau.
Photo #2
Serial Number Location
