38
Sun StorEdge MultiPack User’s Guide • February 1998
FIGURE 2-6
Lining Up the Power Supply Connector Pins
2. Insert the power supply into the unit until the edges of the power supply are flush
against the edge of the chassis.
3. Insert and tighten the four jack screws to secure the board to the power supply
(
).
4. Insert and tighten the two screws to secure the power supply in the enclosure
(
5. Push the pull strap back into the power supply casing.
The pull strap should be pushed in enough so that it is not in the way when you
replace the back cover.
6. Replace the back cover (
7. Insert and tighten the three corner screws and install the lock block to hold the
back panel to the enclosure (
8. Connect the SCSI cable and power cord to the enclosure
9. Turn on the power.