Select the blade and node to view from the left pane.
The node Overview page appears.
Make a note of the node's SP IP address.
You need to know the IP address of the node SP to log in directly to the node ILOM over the
network. By default, the IP address of the node SP is configured using DHCP, if you want to set a
static IP address, see
“Configuring an ILOM IP Address” on page 41
Repeat Step 4 to find the IP address for the server's other node SP.
If you have already selected
Node 0
, for example, now select
Node 1
from the left pane.
▼
How to Display the ILOM IP Address Using the CLI
You need to use the chassis CMM ILOM to display the network configuration for the ILOM
service processor of each server node, including its IP address. This procedure also verifies that
a node's ILOM is working correctly and that you can access it through the CMM ILOM.
The chassis CMM should already be connected to the network using its Ethernet management
port, configured and operational. If not, refer to your chassis documentation before proceeding.
Open a terminal window.
4
5
6
Before You Begin
1
Obtaining the ILOM IP Address
Sun Blade X6275 M2 Server Module Installation Guide • March 2012, Rev A, 7010774
36
