92
Sun Fire T2000 Server Service Manual • October 2005
5. Remove the screw (
FIGURE 4-19
) that secures the power distribution board to the
chassis.
FIGURE 4-19
Removing the Power Distribution Board
6. Slide the power distribution board toward the front of the chassis and remove it
from the chassis (
FIGURE 4-19
).
7. Place the power distribution board on an antistatic mat.
▼
To Replace the Power Distribution Board
Caution –
The system supplies power to the power distribution board even when
the system is powered off. To avoid personal injury or damage to the system, you
must disconnect all power cords before servicing the power distribution board.
1. Loosely fit the power distribution board onto the locator pins in the chassis and
slide the board toward rear of the chassis.
2. Secure the power distribution board to the chassis with the mounting screw.
Do not tighten the screw yet.
3. Secure the power distribution board to the bus bar with two screws, and tighten
all three screws (
FIGURE 4-20
).
Summary of Contents for Netra T2000
