Appendix
-13
2. Enter the number of the disk to be formatted after the
disk
command.
The following screen example uses
disk 2
. The FORMAT MENU appears.
3. Make a note of the device name of the disk.
The device name of the disk in the previous screen example is
c7t16d0.
B.2.2.4
To Specify Slices On the New Boot Disk
After you change to the new boot disk, specify one slice on the new boot disk for
every slice on the temporary boot disk. The following examples specify the root slice
0 on the new boot disk to match slice 0 on the temporary boot disk.
format> disk 2
selecting c7t16d0
[disk formatted]
FORMAT MENU:
disk - select a disk
type - select (define) a disk type
partition - select (define) a partition table
current - describe the current disk
format - format and analyze the disk
repair - repair a defective sector
label - write label to the disk
analyze - surface analysis
defect - defect list management
backup - search for backup labels
verify - read and display labels
save - save new disk/partition definitions
inquiry - show vendor, product and revision
volname - set 8-character volume name
!<cmd> - execute <cmd>, then return
quit
format>
Summary of Contents for StorEdge X6767A
