22
Sun StorEdge SBus Dual Fibre Channel Host Adapter Installation Guide • October 2002
b. Select mode Functional test.
c. Select HostAdapters qlcx, where x is the qlc # of the qlc port you want to run
this test against.
d. If you want to run the external loopback test, place a loopback plug into the qlc
port that you want to test.
If you do not have an external loopback plug, you can make one by taking apart
a fibre cable and plugging the same cable into the transmitter and receiver of the
qlc port.
e. Right click on the qlc test and select Test Parameter Options.
f. Enable the External Loopback Test.
Note –
If you do not use a loopback plug, you can connect the qlc port to storage
devices. In such a case, you will be testing both the qlc and the entire Fibre Channel
loop.
g. Select
Start
to start the test.
Note –
If you select only the external loopback test, the different version diagnostic
tests will not be run and the delay time between tests will be set to zero. This is a
good way to test your Fibre Channel loop if you leave the qlc port attached to
storage devices.
Summary of Contents for StorEdge
