16
Sun Blade 1000 UltraSPARC
TM
CPU Module Installation Instructions • December 2001
4. Complete one of the following steps:
Your selection depends on whether you are replacing an existing UltraSPARC III
module or installing an additional UltraSPARC III module into an unused CPU
processor slot.
■
If you are replacing an existing module and have torque tool A, perform Step 5.
■
If you are replacing an existing module and have torque tool B, perform Step 6.
■
If you are installing an additional CPU module, perform Step 7.
FIGURE 8
Using Torque Tool A to remove the CPU Module
5. To remove an existing CPU module using torque tool A:
Torque tool A
Shroud
CPU module
Left captive
screw
Right captive screw
