Chapter 2
Installing the Fabric Expansion Module
7
2. List the network devices on your system.
You should see the network devices in c) and d) above. If you do not see the
network devices, verify that the FEM is properly seated.
▼
To Reboot the System
●
After verifying the FEM installation, perform a reconfiguration boot on your
system. Type the following:
ok
show-nets
a) /pci@0/pci@0/pci@c/network@0,1
b) /pci@0/pci@0/pci@c/network@0
c) /niu@80/network@1
d) /niu@80/network@0
q) NO SELECTION
Enter Selection, q to quit
ok
boot -r
