Chapter 3
General Management of the Switch
3-117
Scroll down to the VLAN membership table, and configure the VLANs required for
the selected interface.
FIGURE 3-38
The Up Links
⇒
VLANs Window (cont’d)
3.4.4.2
Command-line Interface: Configuring VLAN Behavior for
Interfaces
This example sets port NETP4 to accept only tagged frames, assigns PVID 4 as the
native VLAN ID, enables GVRP, sets the GARP timers, and then sets the switchport
mode to
hybrid
.
Console(config)#
interface ethernet NETP4
Console(config-if)#
switchport acceptable-frame-types tagged
Console(config-if)#
no switchport ingress-filtering
Console(config-if)#
switchport allowed vlan add 4 tagged
Console(config-if)#
switchport native vlan 4
Console(config-if)#
switchport gvrp
Console(config-if)#
garp timer join 10
Console(config-if)#
garp timer leave 90
Console(config-if)#
garp timer leaveall 2000
Console(config-if)#
switchport mode hybrid
Console(config-if)#
switchport forbidden vlan add 3
Console(config-if)#
Summary of Contents for Sun Fire B1600 Administration
