4-38
Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
Example
The following example shows that system logging is enabled, the message level
for Flash memory is
errors
(default level 3 to 0), the message level for RAM is
debugging
(default level 7 to 0), and lists one sample error.
Related Commands
logging on
(
4-34
)
logging history
(
4-35
)
4.3.3.11
show startup-config
Use this command to display the configuration file stored in non-volatile memory
that is used to start up the system.
Default Setting
None
Command Mode
Privileged Exec
Console#
show logging flash
Syslog logging: Enable
History logging in FLASH: level errors
[0] 0:0:5 1/1/1
"PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#show logging ram
Syslog logging: Enable
History logging in RAM: level debugging
[0] 0:0:5 1/1/1
"PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#
Summary of Contents for Sun Fire B1600 Administration
