Sun Microsystems Sun Fire V20z, Replacing

817-5258-11

1

Replacing the Sun Fire v20z or Sun Fire V40z Cable Kit

This document contains:

■

“Replacing a Cable Kit in a Sun Fire V20z Server” on page

1

■

“Replacing a Cable Kit in a Sun Fire V40z Server” on page

3

Replacing a Cable Kit in a Sun Fire V20z Server

Follow these steps to remove and replace the following cables (refer to 

FIGURE

2

):

■

Five-pin cable connecting the SCSI backplane to the motherboard (1).

■

68-pin ribbon cable connecting the SCSI backplane to the motherboard (2).

■

Flat cable connecting the SCSI backplane to the motherboard (3).

■

Flat cable connecting the CD-ROM/DVD to the motherboard (5).

■

Flat cable connecting the Diskette Drive to the motherboard (6).

■

Flat cable connecting the operator panel board to the motherboard (7).

1. Turn off the system, including any attached peripherals.

Refer to the 

Sun Fire V20z and Sun Fire V40z Servers User Guide

 for full instructions 

on powering off the server.

2. While pressing the cover latch release button with your right thumb (A),

slide the 

cover towards the rear of the chassis until it contacts the stop (B).

3. Lift the cover up and remove it. 

FIGURE

1 

Removing the Sun Fire V20z Cover 

A

B