Fiber Optic Solutions Provider
2/3
www.suntelecom.cn • +86-21-60138638 • ics@suntelecom.cn
4.2
Splice fibers, install heat shrinkable protective sleeve
See figure 4 follow user manual of fusion splicing machine to splice fiber
cores. When having completed splicing the fibers, the first fiber ring should
be housed on the farthest side of FOST, the remaining fiber should be winded,
forming a ring with diameter not less than 80mm. then put it into FOST (Fiber
Optic Splice Tray).together with heat shrinkable sleeve for splice protection.
4.3
Check up comprehensively
To ensure the technical requirements, the following instructions must be
followed:
Fibers with protective coat are fixed with nylon tie at the entrance of
FOST.
Grommet should be pressed from inside to outside in order to properly
install FOST.
If there are fibers with protective coat reserved, wind it into the fiber
holding tray.
Check whether the internal tighteners and reinforced core are well
tightened.
Check whether gasket ring is installed neatly and smoothly without any
breakage. If not, level it up with seal tape.
Important issues:
If any problems occur, they should be solved right away.
See figure 5
Figure 4
Figure 5