a. Feed the DC switch assembly power cable through the front of the front
panel.
b. Using a small flat-blade screwdriver, press the detent tab on one side of the
DC switch assembly while pushing the switch into the front panel from the
front.
c. Repeat Step b for the other side of the DC switch assembly.
d. Continue pressing the detent tab on alternate sides and pushing the DC
switch assembly into the front panel until the DC switch assembly locks
into the front panel housing.
2. Replace the front panel (Figure 1–11):
a. Replace the nameplate onto the front panel, ensuring that the light pipe
tabs are oriented with the nameplate cutouts.
b. Feed the DC switch assembly power cable through the chassis front (Figure
1–10).
c. Position the front panel onto the chassis. Using a number 2 Phillips-head
screwdriver, replace the four screws securing the front panel to the chassis.
d. Replace the front panel bezel (not illustrated).
3. Route the DC power cable along the chassis front and side. Secure the power
cable in place using the cable routing clips (Figure 1–10).
4. Connect the DC switch assembly power connector to motherboard connector
J3504 (Figure 1–10).
5. Replace the SCSI drive bay (Figure 1–9):
Caution -
Prior to replacing the SCSI drive bay, ensure that all cables are clear of the
drive bay area in the chassis.
Note -
Hooks at the drive bay base must lock into the bottom slots of the chassis.
a. Slide the SCSI drive bay into the chassis.
20
Sun Ultra 60 Product Note
♦
June 2000, Revision A
