1
Replacing the Chassis
This document describes how to replace the chassis for the Sun Disk Shelf-24x3.5”
SAS-2.
Caution –
Only trained service personnel should remove the covers on this
equipment.
This product is intended for restricted access, whereby access is controlled through
the use of a means of security (for example, key, lock, tool, badge access), and
personnel authorized for access have been instructed on the reasons for the
restrictions and any precautions that need to be taken.
ESD Precautions
When completing the procedures in this guide, observe the following electrostatic
discharge (ESD) precautions:
■
Remove all plastic, vinyl, and foam material from the work area.
■
Wear an antistatic wrist strap at all times when handling any disk shelf
component.
■
Before handling any component, discharge any static electricity by touching a
grounded surface.
■
After removing a component from the disk shelf, immediately place it on an
antistatic surface or in antistatic packaging.
■
Handle any card that is part of a component by its edges only and avoid touching
the components or circuitry.
■
Do not slide a component over any surface.
