Measurement in
progress
Exhaust
pressure
Replace
batteries
Measurement error
Pulse error
Mark appears in the mea-
surement condition and
flashes when pulse is
detected.
Mark flashes when power is
applied and there is air
remaining in the cuff.
Measurement has begun
but the pressure was
insufficient.
Appears when the battery
voltage is excessively low.
Appears when the blood
pressure could not be
obtained accurately.
Appears when the pulse
rate could not be obtained
accurately.
Measurement in progress
remain quiet.
Automatic exhaust is per-
formed.
Raise the cuff
pressure 30-40
more andmeasure once
again.
Replace all four batteries
with new ones.
Exhaust the air from the
cuff, and re-apply the cuff
properly and re-measure.
(Wait 10 minutes before
re-measure)
