READY TO USE
Note:
The
BATTERY INSTALLATION
and
COLLAR FITTING
steps must
be completed before you are ready to use.
STEP 1:
Holding the main body of the Sunbeam® Advanced Bark Control
Collar in both hands PRESS and HOLD the Main Control Button for 4
seconds.
Note:
You will hear 1 audible beep and 3 LEDs flash gREEN indicating the
device is on.
The default correction level is
LOW
; this setting will illuminate green for
10 seconds and then automatically turn off. During the ten seconds, you
may toggle to different correction levels by pressing the Main Control
Button.
The Sunbeam® Advanced Bark Control Collar has been designed to
maximize battery life and has a
SLEEP
MODE
that it enters if no user
input or barking is detected.
STEP 2:
Set correction level by PRESSINg AND HOLDINg (approximately
2 seconds) the Main Control Button until a gREEN LED illuminates at the
desired setting.
When a gREEN LED is illuminated press once the Main Control Button to
toggle to the next correction level.
Once a correction level is chosen
the gREEN LED will turn off and the
system has entered
SLEEP
MODE
.
Note:
It is recommended to start on
the
LOW
setting and monitor your
dog’s behavior before determining if a
higher correction level is needed. The
Sunbeam® Advanced Bark Control
Collar retains the last correction level
setting and will resume this mode
when the unit is turned on.
STEP 3:
Attach collar to your dog as you did in the
COLLAR FITTING
stage.
SPECIAL OPERATING NOTES
SLEEP MODE:
This is the normal operating mode of the bark control
collar. The system has been designed to maximize battery life. You can
verify the status of the system by pressing and holding the Main Control
Button for 2 seconds.
The Sunbeam® Advanced Bark Control Collar retains the LAST correction
5
