7
Before initial use of Kettle
If you are using the kettle for the first time,
it is recommended that you clean your kettle
before use by boiling a full kettle of water
twice and then discarding the water.
Operation:
1. To fill water into the kettle, remove it
from the power base and open the lid
by pressing down on the lid button and
filling the kettle with the desired amount
of water. Always fill the kettle between
the minimum (0.7L) and maximum (1.7L)
marks. Too little water will result in the
kettle switching off before the water has
boiled.
Note: Do not fill the water over the maximum
level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place
before connecting the power cord to the outlet.
2. Close the lid. Position the kettle on the
power base.
3. Connect the plug into a power outlet. Lift
the switch upwards to “I” position and
the switch light illuminates. Then start to
boil the water. The kettle will switch off
automatically once the water has boiled
and the switch light extinguishes. You can
shut off the power by pressing the switch
at any moment during boiling water.
Note: Ensure that switch is clear of
obstructions and the lid is firmly closed.
The kettle will not turn off if the switch is
constrained or if the lid is left open.
4. Lift the kettle from the power base and
then pour the water.
Note: Operate carefully when pouring the
water from the kettle as boiling water may
result in scalds or burns. Do not open the lid
while water is in hot kettle.
5. The kettle will not re-boil until the switch
is uplifted. Allow to cool for 15-20 seconds
before reboiling. The kettle may be stored
on the power base when not in use.
Note: Ensure power supply is turned off when
kettle is not in use.
Dry boil protection
Should you accidentally allow the kettle to
operate without water, the dry boil protection
will automatically switch it off. If this should
occur, allow the kettle to cool before filling
with water and re-boiling.
Using your Kettle
