-E6-
FILLING WATER RESERVOIR (USE TAP WATER)
DRY IRONING
1. Move Steam Lever to Dry
setting.
2. Place the iron with soleplate resting on a flat, clean surface.
3. Open the Water Fill Hole Cover by gripping side tabs and gently pulling out
the cover to open.
4. Use an easy-pour measuring cup to fill water reservoir with tap water through
the Water Fill Hole. Do not fill water reservoir beyond the MAX line.
5. Close the Water Fill Hole Cover securely after filling.
WARNING: To prevent the risk of burns, be careful when filling a hot iron with
water. Hot metal parts, hot water and steam can cause injuries.
1. Ensure Steam Lever is moved to the Dry
setting and iron is locked in
position on the Heating Base on a flat, stable surface (follow instructions for
“Corded Ironing”).
2. Set Fabric Select Dial according to fabric type (Figure 1).
NOTE: If not sure of the fabric type, it is best to first test the temperature of the
iron on a hem or an inside seam.
Figure 1
3. Plug the solid cord into a 120-Volt AC outlet.
• The red Indicator Light comes on to indicate iron is heating up.
• When the Indicator Light turns solid green, the iron has reached required
temperature and is ready for use.
4. To use the iron without the cord, follow instructions for “Cordless Ironing.”
NOTE: While the Steam Lever is turned to the Dry
setting, you may still use
the SHOT OF STEAM
®
or SPRAY MIST
®
feature, as long as the Fabric Select Dial is
set to wool, cotton, or linen / high temperature. Make sure the water reservoir is
approximately ¼ full of water.
-E7-
STEAM IRONING
CORDED IRONING
1. Follow the instructions for “Filling Water Reservoir” and “Corded Ironing.”
2. Move Steam Lever to desired steam setting. Set Fabric Select Dial according to
fabric type (refer to Figure 1).
NOTE: If not sure of the fabric type, it is best to first test the temperature of the
iron on a hem or an inside seam.
3. Plug the cord into a 120-Volt AC outlet.
• The red Indicator Light comes on, to indicate iron is heating up.
• When the Indicator Light turns solid green., the iron has reached required
temperature and is ready for use.
4. To use the iron without the cord, follow instructions for “Cordless Ironing.”
1. Set the iron in vertical position onto the Heating Base.
2. Move Lock/Unlock switch to the locked position . Lift the iron by the handle
to ensure that it is securely locked onto the base (Figure 2).
3. Keep the iron on the heel rest of the Heating Base when not ironing.
Figure 2
