10
Heading
Before using your MultiProcessor
• Wash the processing bowl, cover and all
attachments in warm water using a mild
detergent. Dry each part thoroughly
before use.
• Before you assemble the food processor,
ensure that the power cord is unplugged.
Before using the processing bowl
• The following steps are only necessary for
the MultiProcessor Plus (LC6950).
1. Place the motor base facing you on a dry,
level surface.
2. Fit the safety cover onto the food processor
body and twist anti-clockwise, see Figure 1
Note:
The MultiProcessor Plus processing bowl
will not operate if the safety cover or blender
jug are not in place.
Positioning the processing bowl and cover
The following steps are for both models
LC6250 and LC6950.
1. Place the motor base facing you on a dry,
level surface.
2. Position the processing bowl over the drive
shaft. The handle of the bowl needs to be
facing you (marked “Locate handle”) and
the bowl should now be resting on the base
of the food processor, see Figure 2.
3. To lock the bowl into position for use, turn the
handle to the right, as far as it will go
, see
Figure 3.
4. Place the processor bowl cover onto the
processing bowl, by aligning the icon
marked on the handle with the icon
on
the bowl cover. Then rotate lid to lock,
see Figures 4 and 5.
UNLOCKED
Using your Sunbeam
MultiProcessor
LC6950
Pictured
LC6250
Pictured
LC6250
Pictured
LC6250
Pictured
Fig 1
Fig 2
Fig 3
Fig 4
