12
5. Remove the boiler cap completely.
See fig 7
6. Place the unit on its side and carefully
pour the descaling solution into the
boiler. Replace the cap.
7. Return the unit to the upright position
and leave for 2 minutes.
8. Shake the unit back and forth to
dislodge any scale build up on the base
of the boiler. Leave for 10 minutes.
9. Shake the unit again to swirl the
solution around inside the boiler.
10. Place the unit on a sink or vessel so
that water can be expelled from the
boiler flush cap.
11. Carefully remove the boiler cap and
allow the descaling solution to empty.
12. Rinse with 1 cup (250ml) clean water,
shake and empty. Repeat.
13. Once you have completed the descaling
process, and refilled the tank, the
Calc Clean reminder will no longer
be illuminated. The power light will
illuminate and the unit will begin
heating as normal.
Note:
Sunbeam Steam Ironing System
descaling tablets are available from
selected department stores and electrical
retailers.
Calc Clean instructions – using lemon juice
Alternatively, if you do not have Sunbeam
Ironing System Descaling Tablets, you can
use lemon juice to remove the scale build
up from inside the unit’s boiler.
1. To flush the boiler, turn the unit off
and wait for it to cool completely
(approx 2 hours).
2. Place the unit on a waterproof surface,
or on the edge of the sink.
3. Slowly release the boiler cap to release
any remaining steam. Remove the
boiler cap completely
CAUTION:
if the unit has been used prior
to cleaning the boiler cap will be very hot.
Ensure that the unit has cooled completely
before commencing the Calc cleaning
process.
4. Empty any remaining water from the
boiler.
5. In a small jug, add 1tbs lemon juice to
1 cup (250ml) of water and stir to mix.
6. Place the unit on its side and carefully
pour the lemon solution into the boiler.
Replace the cap.
7. Return the unit to the upright position
and leave for 2 minutes.
8. Shake the unit back and forth to
dislodge any scale build up on the base
of the boiler. Leave for 10 minutes.
9. Shake the unit again to swirl the
solution around inside the boiler.
10. Place the unit on a sink or vessel so
that solution can be expelled from the
boiler flush cap.
11. Carefully remove the boiler cap and
allow the solution to empty.
12. Rinse with 1 cup (250ml) clean water,
shake and empty. Repeat.
13. Once you have completed the descaling
process, and refilled the tank, the
Calc Clean reminder will no longer
be illuminated. The power light will
illuminate and the unit will begin
heating as normal.
Care and Cleaning (continued)
Figure 7
