Page 40
Appendix A - RS232 Control Cable Pinout
IR Emitter Installation
To install the IR Emitter:
The photo to the right s
hows an IR Emitter* installed.
The end of the Emitter is to be mounted in front of
the IR Emitter Window.
Place the emitter on the white tie-down block and
use the tie-down to secure it in place.
Place the emitter cable over the bottom of the cable
box and connect the other end of the emitter to the
appropriate control block*.
Note it may be necessary to use a small amount
of glue to secure the IR emitter in place as most
IR emitters dual stick tape do not adhere well to
powder coated surfaces. Use a small amount of
glue or RTV (Silicon) to secure the emitter in place
yet allowing it to be removed or replaced.
Follow instructions on page 8 to close the cable door.
* Neither the emitter or control block are supplied by
SunBriteTV. See instructions that come with your IR
Emitter and control block to determine how to make the
connections.
IR Emitter
Place IR Emitter Cable
over the bottom of the
cable door.
IR Window
