SunBriteTV DS-5518P, Operator'S Manual

Page 16

TV Installation – Rear Panel Connection Diagrams

1.  Make sure the power of the TV and your receiver is turned off.
2.  Obtain a Coaxial SPDIF cable, connect it to your receiver’s 

coaxial SPDIF digital input and the Coaxial SPDIF connection 

on the LINE OUT port off the back of the TV.

3.  Turn on the TV and your receiver.
Please Note :
1.  If you want pure digital stream for your receiver to decode, 

you must also configure the TV’s OSD Sound->Digital Audio 

Out function. Make sure the option is on Bit Stream.

2.  If your receiver is making static noises when receiving Bit 

Stream, you must use the PCM option instead.

3.  Refer to the receiver’s manual to make sure the receiver is 

configured to receive signals correctly from the TV

1.  Make sure the power of the TV and your receiver is turned off.
2.  Obtain a HDMI to DVI conversion cable; connect the DVI side 

of the conversion cable to the DVI output of your PC, and the 

HDMI side of the conversion cable to the HDMI port off the 

back of TV.

3.  Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC 

and the other end to the VGA Stereo Input Port.

4.  Turn on the power to the TV and the PC.
5.  From the remote control’s source button, or the Source button 

from the TVs panel, switch to HDMI.

Please Note :
1.  For the best picture, set your PC resolution to 1920 x 1080 

at 60 Hz. Refer to the PC or graphic card manual for further 

instructions on how to set your resolution and refresh rate.

2.  Refer to your PC manual for video output requirements of the 

video card.

3.  The TV will turn off automatically if there’s no signal present for 

more than 15 minutes.

4.  If HDMI 1 is already occupied, use HDMI 2 as your connection 

port, and switch source to HDMI 2.

Continued on next page

Connecting with Coaxial SPDIF  Digital (Best)

CONNECTING TO A PC
Connecting with DVI Digital (Best)

1.  Make sure the power of the TV and your receiver is turned 

off.

2.  Obtain a 3.5mm stereo/audio cable (if your amplifier 

audio connection requires RCA audio out jacks you 

will need to obtain an 1/8” Stereo Mini Plug to RCA 

adapter cable). Connect it to your receiver’s audio input 

connection and the 3.5mm stereo/audio connection on 

the Analog Audio port on the back of the TV.

3.  Turn on the TV and your receiver.
Please Note :
1.  If you want pure digital stream for your receiver to 

decode, you must also configure the TV’s OSD Sound-

>Digital Audio Out function. Make sure the option is on 

Bit Stream.

2.  If your receiver is making static noises when receiving Bit
3.  Stream, you must use the PCM option instead.
4.  Refer to the receiver’s manual to make sure the receiver 

is configured to receive signals correctly from the TV

Connecting with RCA Audio Analog (Good)

CONNECTING TO AN EXTERNAL AMPLIFIER OR AMPLIFIED SPEAKERS