SunBriteTV SB-2220HD, Operator'S Manual

SunBriteTV Model SB-2220HD Operator’s Manual

Page 15

Page 15

TV Installation – Rear Panel Connections 

CONNECTINg TO A SATEllITE OR CABlE SET-TOP BOX

1.  Make sure the power of the TV and your set-top box is 

turned off.

2.  Connect a HDMI cable to the HDMI output of your set-top 

box and the other end to the HDMI port off the back of 

your TV.

3.  Turn on the TV and your set-top box.
4.  Use the remote control’s source button or the source 

button on the right side of the TV to switch to HDMI 1.

Please Note :
1.  Refer to the set-top box’s manual, to make sure the set- 

top box is configured to output correctly to the TV.

2.  If HDMI 1 is already occupied, use HDMI 1 as your 

connection port and switch source to HDMI 2.

3.  This SunBriteTV model supports SONY’s universal remote 

code. If SunBriteTV is not listed in the manufacturer list, 

look up SONY’s codes in your universal remote’s hand 

book.

4.  This TV will turn off automatically if there’s no signal 

present for more than 15 minutes.

1.  Make sure the power of TV and your set-top box is turned off.
2.  Obtain a Component Cable. Connect the green color 

connector to both your set-top box and Component 1’s green 

connector port off the back of your TV.

3.  Connect the blue color connector to both your set-top box and 

Component 1’s blue connector port off the back of your TV.

4.  Connect the red color connector to both your set-top box and 

Component 1’s red connector port off the back of your TV.

5.  Obtain a RCA Audio Cable.  Connect the white color connector 

to both your set-top box and Component 1’s white connector 

port off the back of your TV to the right side of your green, 

blue, red component connection.

6.  Connect the red color connector to both your set-top box and 

Component 1’s red connector port off the back of your TV to 

the right side of your green, blue, red component connection.

7.  Turn on the TV and your set-top box.
8.  Use the remote control’s source button or the source button 

on the TV to switch to YPbPr1.

Please Note :
1.  If Component 1 is already occupied, please use Component 2 

is your connection port and switch to source YPbPr2.

2.  Please refer to the set-top box’s manual to make sure the set-

top box is configured to output correctly to the TV.

3.  This SunBriteTV model supports SONY’s universal remote 

code. If SunBriteTV is not listed in the manufacturer list, look 

up SONY’s codes in your universal remote’s hand book.

4.  This TV will turn off automatically if there’s no signal present 

for more than 15 minutes.

Connecting with HDMI (Best)

Connecting with 

Component (Better)