SunBriteTV SB3230HD, Operator'S Manual

Page 12

TV Installation – Rear Panel Connections 

CONNECTING TO AN ANTENNA--(Continued)

Connecting to Cable or Antenna through VCR

1.   Make sure the power of the TV is turned off .

2.   Make sure there is an antenna or cable 
connection to the VCR already.

3.   Use a Coaxial RF cable and connect from your 
VCR’s Antenna Out or Output to TV to the ATSC/
NTSC port off  the back of the TV.

4.   Turn on the TV.

5.   Select TV (Air) for antenna or TV (Cable) for 
digital cable from either your remote control’s 
source button or source button on the TV.
6.   Use the On-Screen Display to scan for channels.

Please Note :

1.     Some VCRs must be turned On before its output will have 
a signal to the TV.  Please consult your VCR manual for further 
reference.

2.     Not all broadcasts are in High Defi nition (HD).  Please refer to 
your local broadcasting stations for more information.

3.     The TV’s tuner is designed for HDTV therefore requires a 
stronger signal than normal TVs.  If you cannot achieve that signal 
level with your antenna or cable, the TV might lose picture or 
sound.

CONNECTING TO A DVD PLAYER 

1.   Make sure the power of the TV and your DVD player is 
turned off .

2.   Connect a HDMI cable to the HDMI port of your DVD 
player and the other end to the HDMI port off  the back of the 
TV.

3.   Turn on the TV and your DVD player.

4.   Use the remote control’s source button or the source 
button on the TV to switch to HDMI.

Please Note :
Refer to the DVD player’s manual to make sure the DVD player 
is confi gured to output correctly to the TV.

1.   Make sure the power of TV  and your DVD player is turned off .

2.   Obtain a Component Cable. Connect the green color connector 
to both your DVD player and Component 1’s green connector port 
off  the back of the TV.

3.   Connect the blue color connector to both your DVD player and
Component 1’s blue connector port off  the back of the TV.

4.   Connect the red color connector to both your DVD player and
Component 1’s red connector port off  the back of the TV.

5.   Obtain a RCA Audio Cable.  Connect the white color connector 
to both your DVD player and Component 1’s white connector port 
off  the back of the TV to the right side of your green, blue, red 
component connection.

6.   Connect the red color connector to both your DVD player and
Component 1’s red connector port off  the back of the TV to the 
right side of your green, blue, red component connection.

7.   Turn on the TV and your DVD player.

8.   Use the remote control’s source button or the source button on 
the TV to switch to YPbPr1.

Please Note :

1.   Refer to the DVD player’s manual to make sure the DVD player 
is confi gured to output correctly to the TV.

Connecting with HDMI (Best)

Connecting with HDMI (Best)

Connecting with 
Component (Better)